Enterasys b5

clear port mirroring
7-42 Port Configuration
Usage
NotethatLAGportsandtheirunderlyingphysicalports,asdescribedin“LinkAggregation
ControlProtocol(LACP)”onpage7‐44,cannotbemirrored.
Example
Thisexampleshowshowtocreateandenableportmirroringwithge.1.4asthesourceport,and
ge.1.11asthetargetport:
B5(su)->set port mirroring create ge.1.4 ge.1.11
clear port mirroring
Usethiscommandtoclearaportmirroringrelationship.
Syntax
clear port mirroring source destination
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampleshowshowtoclearaportmirroringrelationshipbetweensourceportge.1.4and
targetportge.1.11:
B5(su)->clear port mirroring ge.1.4 ge.1.11
set mirror vlan
AssignsaVLANtobereservedformirroringtr.IfamirroredVLANiscreated,allmirroredtraffic
willegressVLANtagged.AlltrafficonthemirrorVLANwillbeflooded.
Syntax
set mirror vlan vlan-id
Parameters
source Specifiesthesourceports(upto8ports)ofthemirroringconfigurationto
becleared.Foradetaileddescriptionofpossibleport‐stringvalues,referto
“PortStringSyntaxUsedintheCLI”onpage7‐1.
destination Specifiesthetargetportofthemirroringconfigurationtobecleared.
vlan‐id SpecifiestheVLANtobeusedforremoteportmirroring.TheIDcan
rangefrom2to4093.