Enterasys b5 User Manual

show radius
Enterasys B5 CLI Reference 22-7
Parameters
Defaults
Ifnoparametersarespecified,allRADIUSconfigurationinformationwillbedisplayed.
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtodisplayRADIUSconfigurationinformation:
B5(rw)->show radius
RADIUS status: Enabled
RADIUS retries: 3
RADIUS timeout: 20 seconds
RADIUS Server IP Address Auth-Port Realm-Type
-------------- ---------- --------- -----------------
10 172.16.20.10 1812 management-access
Table 22‐1providesanexplanationofthecommandoutput.
status (Optional)DisplaystheRADIUSserver’senablestatus.
retries (Optional)DisplaysthenumberofretryattemptsbeforetheRADIUSserver
timesout.
timeout (Optional)Displaysthemaximumamountoftime(inseconds)toestablish
contactwiththeRADIUSserverbeforeretryattempts begin.
server(Optional)
DisplaysRADIUSserverconfigurationinformation.
index|all Forusewiththeserverparametertoshowserverconfigurationforall
serversoraspecificRADIUSserverasdefinedbyanindex.
Table 22-1 show radius Output Details
Output Field What It Displays...
RADIUS status Whether RADIUS is enabled or disabled.
RADIUS retries Number of retry attempts before the RADIUS server times out. The default value of 3
can be reset using the set radius command as described in “set radius” on
page 22-8.
RADIUS timeout Maximum amount of time (in seconds) to establish contact with the RADIUS server
before retry attempts begin. The default value of 20 can be reset using the set
radius command as described in “set radius” on page 22-8.
RADIUS Server RADIUS server’s index number, IP address, and UDP authentication port.
Realm-Type Realm defines who has to go through the RADIUS server for authentication.
• Management-access: This means that anyone trying to access the switch (Telnet,
SSH, Local Management) has to authenticate through the RADIUS server.
• Network-access: This means that all the users have to authenticate to a RADIUS
server before they are allowed access to the network.
• Any-access: Means that both Management-access and Network-access have
been enabled.

Enterasys b5 Specifications

General

Brand	Enterasys
Model	b5
Category	Other
Language	English