Enterasys b5

set cos state
Enterasys B5 CLI Reference 11-19
Commands
set cos state
UsethiscommandtoenableordisableClassofService.
Syntax
set cos state {enable | disable}
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
For information about... Refer to page...
set cos state 11-19
show cos state 11-20
clear cos state 11-20
set cos settings 11-21
clear cos settings 11-22
show cos settings 11-22
set cos port-config 11-23
show cos port-config 11-24
clear cos port-config 11-25
set cos port-resource irl 11-26
set cos port-resource flood-ctrl 11-27
show cos port-resource 11-28
clear cos port-resource irl 11-29
clear cos port-resource flood-ctrl 11-30
set cos reference 11-30
show cos reference 11-31
clear cos reference 11-32
show cos unit 11-33
clear cos all-entries 11-33
show cos port-type 11-34
enable|disable EnablesordisablesClassofServiceontheswitch.Defaultstateis
disabled.