Enterasys b5 - Set Policy Profile

set policy profile
11-4 Policy Classification Configuration
set policy profile
Usethiscommandtocreateapolicyprofileentry.
Syntax
set policy profile profile-index [name name] [pvid-status {enable | disable}]
[pvid pvid] [cos-status {enable | disable}] [cos cos] [egress-vlans egress-
vlans][forbidden-vlans forbidden-vlans] [untagged-vlans untagged-vlans]
[precedence precedence-list] [append] [clear]
Parameters
profile‐index Specifiesanindexnumberforthepolicyprofile.Validvaluesare1‐255 .
namename (Optional)Specifiesanameforthepolicyprofile.Thisisastringfrom1to
64characters.
pvid‐status
enable|disable
(Optional)EnablesordisablesPVIDoverrideforthisprofile.Ifall
classificationrules
associatedwiththisprofilearemissed,thenthis
parameter,ifspecified,determinesdefaultbehavior.
pvidpvid (Optional)Specifies thePVIDtopackets,ifPVIDoverrideisenabledand
invokedasdefaultbehavior.
cos‐statusenable
|disable
(Optional)EnablesordisablesClassofServiceoverrideforthisprofile.Ifall
classificationrulesassociated
withthisprofilearemissed,thenthis
parameter,ifspecified,determinesdefaultbehavior.
Note: A maximum of 99 rules can be supported per policy profile for policy profiles
that have cos-status enabled.
coscos (Optional)SpecifiesaCoSvaluetoassigntopackets,ifCoSoverrideis
enabledandinvokedasdefaultbehavior.Validvaluesare 0to7.
egress‐vlans
egress‐vlans
(Optional)Specifiesthattheporttowhichthispolicyprofileisapplied
shouldbeaddedtotheegresslistofthe
VLANsdefinedbyegress‐vlans.
Packetswillbeformattedastagged.
forbidden‐vlans
forbidden‐vlans
(Optional)Specifiesthattheporttowhichthispolicyprofileisapplied
shouldbeaddedasforbiddentotheegresslistoftheVLANsdefinedby
forbidden‐vlans.Packetsfromthisportwillnotbe
allowedtoparticipatein
thelistedVLANs.
untagged‐vlans
untagged‐vlans
(Optional)Specifiesthattheporttowhichthispolicyprofileisapplied
shouldbeaddedtotheegresslistoftheVLANsdefinedbyuntagged‐vlans.
Packetswillbeformattedasuntagged.
append (Optional)Appendsthispolicyprofilesettingtosettings
previously
specifiedforthispolicyprofilebytheegress‐vlans,forbidden‐vlans,or
untagged‐vlansparameters.
Ifappendisnotused,previousVLANsettingsare replaced.
clear (Optional)Appendsthispolicyprofilesettingfromsettingspreviously
specifiedforthispolicyprofilebytheegress‐vlans,forbidden‐vlans,or
untagged‐vlansparameters.
precedence

precedence‐list
(Optional)Assignsaruleprecedencetothisprofile.Lowervalueswillbe
givenhigherprecedence.Foralistofvalues,refertotheshowpolicy
profilecommandoutput.