Enterasys b5

router rip
20-2 IPv4 Routing Protocol Configuration
Router Configuration Commands
ThefollowingcommandsareusedtoenterRIProuterconfigurationmodeandtoconfigureRIP
routing.
router rip
UsethiscommandtoenableordisableRIPconfigurationmode.Thenoformofthiscommand
disablesRIP.
Syntax
router rip
no router rip
Parameters
None.
Defaults
None.
Mode
Globalconfiguration:B5(su)‐>router(Config)#
Usage
YoumustexecutetherouterripcommandtoenabletheprotocolbeforecompletingmanyRIP‐
specificconfigurationtasks.Fordetailsonenablingconfigurationmodes,refertoTable 18‐2in
“EnablingRouterConfigurationModes”onpage18‐2.
Control reception of routing updates “receive-interface” on page 20-6
Control advertising non-RIP routes. “redistribute” on page 20-6
Table 20-1 RIP Configuration Task List and Commands (Continued)
To do this... Use these commands...
For information about... Refer to page...
router rip 20-2
distance 20-3
no auto-summary 20-4
split-horizon poison 20-4
passive-interface 20-5
receive-interface 20-6
redistribute 20-6