Enterasys b5 User Manual

Using the Command Line Interface
1-6 Introduction
Using the Command Line Interface
Starting a CLI Session
Connecting Using the Console Port
ConnectaterminaltothelocalconsoleportasdescribedinyourEnterasysB5InstallationGuide.
Thestartupscreen,Figure 1‐1,willdisplayontheterminal.YoucannowstarttheCommandLine
Interface(CLI)by
•usingadefaultuseraccount,asdescribedin“UsingaDefaultUserAccount”
onpage 1‐7,or
•usinganadministratively‐assigneduseraccountasdescribedin“UsinganAdministratively
ConfiguredUserAccount”onpage 1‐7.
Figure 1-1 Enterasys B5 Startup Screen
Connecting Using Telnet
OncetheEnterasysB5devicehasavalidIPaddress,youcanestab lishaTelnetsessionfromany
TCP/IPbasednodeonthenetwork.Forinformationaboutsettingtheswitch’sIPaddress,referto
“setipaddress”onpage 3 ‐10.
ToestablishaTelnetsession:
Telnet port (IP) Set to port number 23.
Timers (OSPF) SPF delay set to 5 seconds. SPF holdtime set to 10 seconds.
Transmit delay (OSPF) Set to 1 second.
VRRP Disabled.
Table 1-2 Default Settings for Router Operation (Continued)
Output... What it displays...
Username:admin
Password:
Enterasys Enterasys B5
Command Line Interface
Enterasys Networks, Inc.
50 Minuteman Rd.
Andover, MA 01810-1008 U.S.A.
Phone: +1 978 684 1000
E-mail: support@enterasys.com
WWW: http://www.enterasys.com
(c) Copyright Enterasys Networks, Inc. 2011
Chassis Serial Number: 041800249041
Chassis Firmware Revision: 6.42.xx.xxxx
B5(su)->

Enterasys b5 Specifications

General

Brand	Enterasys
Model	b5
Category	Other
Language	English