Enterasys b5

Event Group Commands
Enterasys B5 CLI Reference 15-13
Event Group Commands
Purpose
TodisplayandclearRMONevents, andtoconfigureRMONeventproperties.
Commands
show rmon event
UsethiscommandtodisplayRMONevententryproperties.
Syntax
show rmon event [index]
Parameters
Defaults
Ifindexisnotspecified,informationaboutallRMONentrieswillbedisplayed.
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtodisplayRMONevententry3:
B5(rw)->show rmon event 3
Index 3
----------------
Owner = Manager
Status = valid
Description = STP Topology change
Type = log-and-trap
Community = public
Last Time Sent = 0 days 0 hours 0 minutes 37 seconds
Table 15‐3providesanexplanationofthecommandoutput.
For information about... Refer to page...
show rmon event 15-13
set rmon event properties 15-14
set rmon event status 15-15
clear rmon event 15-15
index (Optional)DisplaysRMONpropertiesandlogentriesforaspecificentry
indexID.