Enterasys b5

To Next Page

To Previous Page

set authentication login

Enterasys B5 CLI Reference 22-5

set authentication login

Usethiscommandtosettheauthenticationloginmethod.

Syntax

set authentication login {any | local | radius | tacacs}

Parameters

Defaults

Ifthiscommandisnotexecuted,thedefaultloginmethodis“any.”

Mode

Switchcommand,Read‐Write.

Example

Thisexampleshowshowtosettheauthenticationloginmethodtousethelocalpasswordsettings:

B5(rw)->set authentication login local

clear authentication login

Usethiscommandtoresettheauthenticationloginmethodtothedefaultsettingof“any”.

Syntax

clear authentication login

Parameters

None.

Defaults

None.

Mode

Switchcommand,Read‐Write.

any Specifiesthattheauthenticationprotocolwillbeselectedusingthe

followingprecedenceorder:

•TACACS+

•RADIUS

•Local

local Specifiesthatthelocalnetworkpasswordsettingswillbeusedfor

authenticationlogin.

radius Specif iesthatRADIUSwillbeusedforauthenticationlogin.

tacacs SpecifiesthatTACACS+willbeusedforauthenticationlogin.