Enterasys b5

set dhcp pool client-name
Enterasys B5 CLI Reference 16-19
set dhcp pool client-name
UsethiscommandtoassignanametoaDHCPclientwhencreatinganaddresspoolformanual
binding.
Syntax
set dhcp pool poolname client-name name
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampleconfigurestheclientname“appsvr1”tothemanualbindingpool“manual2.”
B5(rw)->set dhcp pool manual2 client-identifier 01:22:33:44:55:66
B5(rw)->set dhcp pool manual2 host 10.12.1.10 255.255.255.0
B5(rw)->set dhcp pool manual2 client-name appsvr1
clear dhcp pool client-name
UsethiscommandtodeleteaDHCPclientnamefromanaddresspoolformanualbinding.
Syntax
clear dhcp pool poolname client-name
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampledeletestheclientnamefromthemanualbindingpool“manual2.”
B5(rw)->clear dhcp pool manual2 client-name
poolname Specifiesthenameoftheaddresspool.Poolnamesmaybeupto31
charactersinlength.
name Specifiesthenametobeassignedtothisclient.Clientnamesmaybeupto
31charactersinlength.
poolname Specifiesthenameoftheaddresspool.Poolnamesmaybeupto31
charactersinlength.