To Next Page

To Previous Page

set linkflap globalstate

7-28 Port Configuration

set linkflap globalstate

Usethiscommandtogloballyenableordisablethelinkflapdetectionfunction.

Syntax

set linkflap globalstate {disable | enable}

Parameters

Defaults

Bydefault,thefunctionisdisabledgloballyandonallports.

Mode

Switchmode,read‐write.

Usage

Bydefault,thefunctionisdisabledgloballyandonallports.Ifdisabledgloballyafterper‐port

settingshavebeenconfiguredusingthelinkflapcommands,per‐portsettingswillberetained.

Example

Thisexampleshowshowtogloballyenablethelinktrapdetectionfunction.

B5(rw)->set linkflap globalstate enable

set linkflap portstate

Usethiscommandtoenableordisablelinkflapmonitoringononeormoreports.

Syntax

set linkflap portstate {disable | enable} [port-string]

Parameters

Defaults

Ifport‐stringisnotspecified,allportsareenabledordisabled.

TimeElapsed Time (in seconds) since the last link down event.

Violations Number of link flap violations on listed ports since system start.

Table 7-5 show linkflap metrics Output Details (Continued)

Output Field What it displays...

disable|enable Globallydisablesorenablesthelinkflapdetectionfunction.

disable|enable Disablesorenablesthelinkflapdetectionfunction.

port‐string (Optional)Specifiestheportorportsonwhichtodisableorenable

monitoring.

Enterasys b5 User Manual

Questions and Answers: