Enterasys b5 User Manual

set spantree
Enterasys B5 CLI Reference 9-7
set spantree
UsethiscommandtogloballyenableordisabletheSpanningTreeprotocolontheswitch.
Syntax
set spantree {disable | enable}
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtodisableSpanningTreeonthedevice:
B5(su)->set spantree disable
show spantree version
UsethiscommandtodisplaythecurrentversionoftheSpanningTreeprotocolrunningonthe
device.
Syntax
show spantree version
Parameters
None.
Bridge Hello Time Amount of time (in seconds) the bridge sends BPDUs. This is a default
value, or is assigned using the set spantree hello command. For details,
refer to “set spantree hello” on page 9-18.
Bridge Forward Delay Amount of time (in seconds) the bridge spends in listening or learning
mode. This is a default value, or is assigned using the set spantree
fwddelay command. For details, refer to “set spantree fwddelay” on
page 9-20.
Topology Change Count Number of times topology has changed on the bridge.
Time Since Top Change Amount of time (in days, hours, minutes and seconds) since the last
topology change.
Max Hops Maximum number of hops information for a particular Spanning Tree
instance may traverse (via relay of BPDUs within the applicable MST
region) before being discarded.
Table 9-1 show spantree Output Details (Continued)
Output What It Displays...
disable|enable GloballydisablesorenablesSpanningTree.

Enterasys b5 Specifications

General

Brand	Enterasys
Model	b5
Category	Other
Language	English