Enterasys b5

Configuring Spanning Tree Port Parameters
9-34 Spanning Tree Configuration
Configuring Spanning Tree Port Parameters
Purpose
TodisplayandsetSpanningTreeportparameters.
Commands
set spantree portadmin
UsethiscommandtodisableorenabletheSpanningTreealgorithmononeormoreports.
Syntax
set spantree portadmin port-string {disable | enable}
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
For information about... Refer to page...
set spantree portadmin 9-34
clear spantree portadmin 9-35
show spantree portadmin 9-35
show spantree portpri 9-36
set spantree portpri 9-36
clear spantree portpri 9-37
show spantree adminpathcost 9-38
set spantree adminpathcost 9-38
clear spantree adminpathcost 9-39
show spantree adminedge 9-39
set spantree adminedge 9-39
clear spantree adminedge 9-40
show spantree operedge 9-41
port‐string Specifiestheport(s)forwhichtoenableordisableSpanningTree.Fora
detaileddescriptionofpossibleport‐stringvalues,referto“ PortString
SyntaxUsedintheCLI”onpage 7‐1.
disable|ena ble DisablesorenablesSpanningTree.