Enterasys b5

set switch movemanagement
2-10 Configuring Switches in a Stack
set switch movemanagement
Usethiscommandtomovemanagementswitchfunctionalityfromoneswitchtoanother.
Syntax
set switch movemanagement fromunit tounit
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampleshowshowtomovemanagementfunctionalityfromswitch1toswitch2:
B5(su)->set switch movemenagement 1 2
Moving stack management will unconfigure entire stack including all interfaces.
Are you sure you want to move stack management? (y/n) y
set switch member
Usethiscommandtoaddavirtualmembertoastack.Thisallowsyoutopreconfigureaswitch
beforethephysicaldeviceisactuallyaddedtothestack.
Syntax
set switch member unit switch-id
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Usage
Referto“CreatingaVirtualSwitchConfiguration”onpage2‐3formoreinformationabouthowto
addavirtualswitchtoastack.
fromunit Specifiestheunitnumberofthecurrentmanagementswitch.
tounit Specifiestheunitnumberofthenewly‐designatedmanagementswitch.
unit Specifiesaunitnumberfortheswitch.
switch‐id SpecifiesaswitchID(SID)fortheswitch.SIDscanbedisplayedwiththe
showswitchswitchtypecommand.