Enterasys b5

set lldp port trap
6-26 Discovery Protocol Configuration
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleenablesbothtransmittingLLDPDUsandreceivingandprocessingLLDPDUsfrom
remotesystemsonportsge.1.1throughge.1.6.
B5(rw)->set lldp port status both ge.1.1-6
set lldp port trap
UsethiscommandtoenableordisablesendingLLDPnotifications(traps)whenaremotesystem
changeisdetected.
Syntax
set lldp port trap {enable | disable} port-string
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleenablestransmittingLLDPtrapsonportsge.1.1throughge.1.6.
B5(rw)->set lldp port trap enable ge.1.1-6
set lldp port med-trap
UsethiscommandtoenableordisablesendinganLLDP‐MEDnotificationwhenachangeinthe
topologyhasbeensensedontheport(thatis,aremoteendpointdevicehasbeenattachedor
removedfromtheport).
Syntax
set lldp port med-trap {enable | disable} port-string
port‐string Specifiestheportorrangeofportstobeaffected.
enable EnabletransmittingLLDPtrapsonthespecifiedports.
disable Disabletransmi ttingLLDPtrapsonthespecifiedports.
port‐string Specifiestheportorrangeofportstobeaffected.