Enterasys b5

show lldp
Enterasys B5 CLI Reference 6-15
show lldp
UsethiscommandtodisplayLLDPconfigurationinformation.
Syntax
show lldp
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtodisplayLLDPconfigurationinformation.
B5(ro)->show lldp
Message Tx Interval : 30
Message Tx Hold Multiplier : 4
Notification Tx Interval : 5
MED Fast Start Count : 3
Tx-Enabled Ports : ge.1.1-60; ge.2.1-24; ge.3.1-30; ge.4.1-12;
Rx-Enabled Ports : ge.1.1-60; ge.2.1-24; ge.3.1-30; ge.4.1-12;
Trap-Enabled Ports : ge.1.1-60; ge.2.1-24; ge.3.1-30; ge.4.1-12;
MED Trap-Enabled Ports : ge.1.1-60; ge.2.1-24; ge.3.1-30; ge.4.1-12;
show lldp port status
UsethiscommandtodisplaytheLLDPstatusofoneormoreports.Thecommandliststheports
thatareenabledtosendandreceiveLLDPPDUs.Portsareenabledordisabledwiththesetlldp
portstatuscommand.
Syntax
show lldp port status [port-string]
clear lldp 6-31
clear lldp port status 6-31
clear lldp port trap 6-32
clear lldp port med-trap 6-32
clear lldp port location-info 6-33
clear lldp port network-policy 6-33
clear lldp port tx-tlv 6-34
For information about... Refer to page...