Enterasys b5

To Next Page

To Previous Page

set console baud

Enterasys B5 CLI Reference 3-31

Mode

Switchcommand,read‐only.

Example

Thisexampleshowshowtodisplayallconsolesettings:

B5(su)->show console

Baud Flow Bits StopBits Parity

------ ------- ---- ---------- ------

9600 Disable 8 1 none

set console baud

Usethiscommandtosettheconsoleportbaudrate.

Syntax

set console baud rate

Parameters

Defaults

None.

Mode

Switchcommand,read‐write.

Example

Thisexampleshowshowtosettheconsoleportbaudrateto19200:

B5(su)->set console baud 19200

Downloading a Firmware Image

YoucanupgradetheoperationalfirmwareintheEnterasysB5switchwithoutphysicallyopening

theswitchorbeinginthesamelocation.Therearetwowaystodownloadfirmwaretotheswitch:

•ViaTFTPdownload.ThisprocedureusesaTFTPserverconnectedtothenetworkand

downloadsthefirmwareusing the

TFTPprotocol.FordetailsonhowtoperformaTFTP

downloadusingthecopycommand,referto“copy”onpage3‐44.Forinformationonsetting

TFTPtimeoutandretryparameters,referto“settftptimeout”onpage3‐46and“settftp

retry”onpage3‐

47.

•Viatheserial(console)port.Thisprocedureisanout‐of‐bandoperationthatcopiesthe

firmwarethroughtheserialporttotheswitch.Itshouldbeusedincaseswhenyoucannot

connecttheswitchtoperformthein‐bandcopydownl oadprocedureviaTFTP.Serialconsole

downloadhas

beensuccessfullytestedwiththefollowingapplications:

–TeraTermProVersion2.3

rate Setstheconsolebaudrate.Validvaluesare:1200,2400,4800,9600,19200,38400,

57600,and115200.