Enterasys b5

Configuring Broadcast Suppression
Enterasys B5 CLI Reference 7-35
Configuring Broadcast Suppression
Purpose
Toreviewandsetthebroadcastsuppressionthresholdforoneormoreports.Thisfeaturelimits
thenumberofreceivedbroadcastframestheswitchwillacceptperport.Broadcastsuppression
thresholdsapplyonlytobroadcasttraffic—multicasttrafficisnotaffected.Bydefault,abroadcast
suppressionthresholdof14881packetspersecond
(pps)willbeused,regardlessofactualport
speed.BroadcastsuppressionprotectsagainstbroadcaststormsandARPsweeps.
Commands
show port broadcast
Usethiscommandtodisplayportbroadcastsuppressionthresholds.
Syntax
show port broadcast [port-string]
Parameters
Defaults
Ifport‐stringisnotspecified,broadcaststatusofallportswillbedisplayed.
Mode
Switchcommand,read‐only.
Example
Thisexampleshowshowtodisplaythebroadcastsuppressionthresholdsforports1through4:
B5(su)->show port broadcast ge.1.1-4
Port Total BC Threshold
Packets (pkts/s)
----------------------------------------
ge.1.1 0 50
ge.1.2 0 50
ge.1.3 0 40
ge.1.4 0 14881
For information about... Refer to page...
show port broadcast 7-35
set port broadcast 7-36
clear port broadcast 7-36
port‐string (Optional)Selecttheportsforwhichtoshowbroadcastsuppression
thresholds.Foradetaileddescriptionofpossibleport‐stringvalues,refer
to“PortStringSyntaxUsedintheCLI”onpage7‐1.