Enterasys b5

To Next Page

To Previous Page

set newaddrtrap

7-34 Port Configuration

Parameters

Defaults

Ifport‐stringisnotspecified,thetrapfunctionissetglobally.

Mode

Switchmode,read‐write.

Usage

ThiscommandenablesanddisablessendingSNMPtrapmessageswhenanewsourceMAC

addressisdetectedbyaport.IftheportisaCDPport,however,trapsfornewsourceMAC

addresseswillnotbesent.

Thedefaultmodeisdisabledgloballyandperport.

Example

Thisexampleenablesthetrapfunctiongloballyandthenonports1through5inunit/slot1.

B5(rw)->set newaddrtrap enable

B5(rw)->set newaddrtrap ge.1.1-5 enable

port‐string (Optional)EnableordisablethenewMACaddressestrapfunctionon

specificports.

enable|disable EnableordisablethenewMACaddressestrapfunction.Ifentered

withouttheport‐stringparameter,enablesordisablesthefunction

globally.Whenenteredwiththeport‐stringparameter,enablesor

disablesthefunction

onspecificports.