Enterasys b5

reset
3-50 Basic Configuration
reset
Usethiscommandtoresettheswitchwithoutlosinganyuser‐definedconfigurationsettings.
Syntax
reset [unit]
Parameters
Defaults
IfnounitIDisspecified,theentiresystemwillbereset.
Mode
Switchcommand,read‐write.
Usage
AEnterasysB5switchcanalsoberesetwiththeRESETbuttonlocatedonitsfrontpanel.For
informationonhowtodothis,refertotheEnterasysB5InstallationGuideshippedwithyour
switch.
Examples
Thisexampleshowshowtoresetthesystem:
B5(su)->reset
Are you sure you want to reload the stack? (y/n) y
Saving Configuration to stacking members
Reloading all switches.
Thisexampleshowshowtoresetunit1:
B5(su)->reset 1
Are you sure you want to reload the switch? (y/n) y
Reloading switch 1.
This switch is manager of the stack.
STACK: detach 3 units
clear config
Usethiscommandtocleartheuser‐definedconfigurationparameters.
Syntax
clear config [all]
Parameters
unit (Optional)Specifiesaunittobereset.
all (Optional)Clearsuser‐definedconfigurationparameters(andstackunit
numbersandpriorities,ifapplicable).