Enterasys b5

clear port lacp
7-56 Port Configuration
Defaults
Atleastoneparametermustbeenteredperport‐string.
Ifenableordisablearenotspecified,port(s)willbeenabledwiththeLACPparametersentered.
Mode
Switchcommand,read‐write.
Usage
LACPcommandsandparametersbeginningwithan“a”(suchasaadminkey)setacto rvalues.
Correspondingcommandsandparametersbeginningwitha“p”(suchaspadminkey)set
correspondingpartnervalues.ActorreferstothelocaldeviceparticipatinginLA CPnegotiation,
whilepartnerreferstoitsremotedevicepartnerattheother
endofthenegotiation.Actorsand
partnersmaintaincurrentstatusoftheotherviaLACPDUscontaininginformationabouttheir
ports’LACPstatusandoperationalstate.
Example
Thisexampleshowshowtosettheactoradminkeyto3555forportge.3.16andenableLACPon
theport:
B5(su)->set port lacp port ge.3.16 aadminkey 3555 enable
clear port lacp
Usethiscommandtoclearlinkaggregationsettingsforoneormoreports.
Syntax
clear port lacp port port-string {[aadminkey] [aportpri] [asyspri] [aadminstate
{lacpactive | lacptimeout | lacpagg | lacpsync | lacpcollect | lacpdist | lacpdef
| lacpexpire | all}] [padminsyspri] [padminsysid] [padminkey] [padminportpri]
[padminport] [padminstate {lacpactive | lacptimeout | lacpagg | lacpsync |
lacpcollect | lacpdist | lacpdef | lacpexpire | all}]}
Parameters
padminsysid
padminsysid
Setsadefaultvaluetouseastheport’spartnersystemID.ThisisaMAC
address.
padminsyspri
padminsyspri
Setsadefaultvaluetouseastheport’spartnerpriority.Validvaluesare0
‐65535,withlowervaluesgivenhigherpriority.
portport‐string Specifiesthephysicalport(s)onwhichLACPsettingswillbecleared.For
adetaileddescriptionofpossibleport‐stringvalues,referto“PortString
SyntaxUsedintheCLI”onpage7‐1.
aadminkey Clearsaport’sacto radminkey.
aportpri Clearsaport’sactorportpriority.
asyspri
Clearstheport’sact orsystempriority.