Enterasys b5 User Manual

show system hardware
Enterasys B5 CLI Reference 3-15
show system hardware
Usethiscommandtodisplaythesystem’shardwareconfiguration.
Syntax
show system hardware
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐only.
Example
Thisexampleshowshowtodisplaythesystem’shardwareconfiguration.Pleasenotethatthe
informationyouseedisplayedmaydifferfromthisexample.
B5(su)->show system hardware
SLOT 1 HARDWARE INFORMATION
---------------------------
Model:
Serial Number: 777777777777
Vendor ID: 0xbc00
Base MAC Address: 00:11:88:B1:76:C0
Hardware Version: BCM56514 REV 1
FirmWare Version: 01.00.00.0052
Boot Code Version: 01.00.42
Temp alarm syslog Indicates whether temperature alarm syslog messages are enabled or disabled.
The default is disabled.
Thermal Sensor/Ther-
mal Threshold
Lists the type of thermal sensor (power supply, system) and the percentage of
thermal threshold reached for that sensor. The status will show NA (not avail-
able) on switches that do not support this functionality.
Uptime d,h:m:s System uptime.
Logout Time an idle console or Telnet CLI session will remain connected before timing
out. Default of 5 minutes can be changed with the set logout command (“set
logout” on page 3-30).
Table 3-4 show system Output Details (Continued)
Output What It Displays...

Enterasys b5 Specifications

General

Brand	Enterasys
Model	b5
Category	Other
Language	English