Enterasys b5

clear logging application
Enterasys B5 CLI Reference 14-9
Example
ThisexampleshowshowtosettheseveritylevelforSNMPto4sothaterrorconditionswillbe
loggedforthatapplication.
B5(rw)->set logging application SNMP level 4
clear logging application
Usethiscommandtoresettheloggingseveritylevelforoneorallapplicationstothedefaultvalue
of6(notificationsofsignificantconditions).
Syntax
clear logging application {mnemonic | all}
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampleshowshowtoresettheloggi ngseveritylevelto6for SNMP.
B5(rw)->clear logging application SNMP
show logging local
Usethiscommandtodisplaythestateofmessageloggingtotheconsoleandapersistentfile.
Syntax
show logging local
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐only.
mnemonic Resetstheseveritylevelforaspecificapplicationto6. Validmnemonic
valuesandtheircorrespondingapplicationsare listedinTable 14‐3 on
page 14‐8.
all Resetstheseveritylevelforallapplicationsto6.