Enterasys b5 User Manual

set cdp state
Enterasys B5 CLI Reference 6-3
set cdp state
UsethiscommandtoenableordisabletheCDPdiscoveryprotocolononeormoreports.
Syntax
set cdp state {auto | disable | enable} [port-string]
Parameters
Defaults
Ifport‐stringisnotspecified,theCDPstatewillbegloballyset.
Mode
Switchcommand,read‐write.
Examples
ThisexampleshowshowtogloballyenableCDP:
B5(su)->set cdp state enable
ThisexampleshowshowtoenabletheCDPforportge.1.2:
B5(su)->set cdp state enable ge.1.2
ThisexampleshowshowtodisabletheCDPforportge.1.2:
B5(su)->set cdp state disable ge.1.2
CDP Authentication
Code
Authentication code for CDP discovery protocol. The default of 00-00-00-00-00-00-
00-00 can be reset using the set cdp auth command. For details, refer to “set cdp
auth” on page 6-4.
CDP Transmit
Frequency
Frequency (in seconds) at which CDP messages can be transmitted. The default of
60 seconds can be reset with the set cdp interval command. For details, refer to “set
cdp interval” on page 6-4.
Port Port designation. For a detailed description of possible port-string values, refer to
“Port String Syntax Used in the CLI” on page 7-1.
Status Whether CDP is enabled, disabled or auto-enabled on the port.
Table 6-1 show cdp Output Details (Continued)
Output Field What It Displays...
auto|disable|
enable
Auto‐enables,disablesorenables theCDPprotocolonthespecifiedport(s).
Inauto‐enablemode,whichisthedefaultmodeforallports,aport
automaticallybecomesCDP‐enableduponreceivingitsfirstCDPmessage.
port‐string (Optional)EnablesordisablesCDPonspecificport(s).For
adetailed
descriptionofpossibleport‐stringvalues,referto“PortStringSyntaxUsed
intheCLI”onpage7‐1.

Enterasys b5 Specifications

General

Brand	Enterasys
Model	b5
Category	Other
Language	English