Enterasys b5

Configuring Simple Network Time Protocol (SNTP)
Enterasys B5 CLI Reference 14-29
Example
Thisexampleenablesmulticastfloodprotection.
B5(su)->set mac unreserved-flood enable
Configuring Simple Network Time Protocol (SNTP)
Purpose
ToconfiguretheSimpleNetworkTimeProtocol(SNTP),whichsynchronizesdeviceclocksina
network.
Commands
show sntp
UsethiscommandtodisplaySNTPclientsettings.
Syntax
show sntp
Note: A management IP (host, routing interface, or loopback) address must be configured for SNTP
to work..
For information about... Refer to page...
show sntp 14-29
set sntp client 14-31
clear sntp client 14-31
set sntp server 14-32
clear sntp server 14-32
set sntp poll-interval 14-33
clear sntp poll-interval 14-33
set sntp poll-retry 14-34
clear sntp poll-retry 14-34
set sntp poll-timeout 14-35
clear sntp poll-timeout 14-35
set timezone 14-36
show sntp interface 14-37
set sntp interface 14-37
clear sntp interface 14-38