Enterasys b5 User Manual

Authentication Capacities
A-2 Policy and Authentication Capacities
Authentication Capacities
Refertothe“ConfiguringUserAuthentication”FeatureGuideforanin‐depthdiscussionof
authenticationconfiguration.ThisFeatureGuideislocatedontheEnterasysNetworkswebsite:
https://extranet.enterasys.com/downloads/
udp dest port/udp source port cos/drop/fwd
icmp type
1
No
1. These rules cannot be masked.
2. Ether type to vlan rules require that multiauth numusers = 1 (that is, only one authenticated user is
allowed per port).
Table A-1 Policy Capacities (Continued)
Feature Capacity
Table A-2 Authentication Capacities
Authentication Feature Capacity
IEEE 802.1x (dot1x) authentication Supported
MAC-based authentication Supported
Port Web Authentication (PWA) Supported
RFC 3580 dynamic VLAN assignment based on
authentication response
Supported, for 802.1x, MAC-based, and PWA
authentication methods
Multi-user authentication maximum users per port
when policy maptable response is:
policy mode 4
both, hybrid mode 4
tunnel mode 4
User + IP phone
(Configured with a policy admin rule)
Multiauth numusers set to 2 or greater
Supported

Enterasys b5 Specifications

General

Brand	Enterasys
Model	b5
Category	Other
Language	English