Enterasys b5

To Next Page

To Previous Page

set dhcp

16-4 DHCP Server Configuration

set dhcp

UsethiscommandtoenableordisabletheDHCPserverfunctionalityontheEnterasysB5.

Syntax

set dhcp {enable | disable}

Parameters

Defaults

None.

Mode

Switchcommand,read‐write.

Example

ThisexampleenablesDHCPserverfunctionality.

B5(rw)->set dhcp enable

set dhcp bootp

UsethiscommandtoenableordisableautomaticaddressallocationforBOOTPclients.By

default,addressallocationforBOOTPclientsisdisabled.RefertoRFC1534,“Interoperation

BetweenDHCPandBOOTP,”formoreinformation.

Syntax

set dhcp bootp {enable | disable}

Parameters

clear dhcp conflict 16-6

set dhcp exclude 16-7

clear dhcp exclude 16-7

set dhcp ping 16-8

clear dhcp ping 16-8

show dhcp binding 16-9

clear dhcp binding 16-9

show dhcp server statistics 16-10

clear dhcp server statistics 16-11

For information about... Refer to page...

enable|disable EnablesordisablesDHCPserverfunctionality.Bydefault,DHCPserveris

disabled.

enable|disable EnablesordisablesaddressallocationforBOOTPclients.