Enterasys SecureStack B3

clear tftp retry
SecureStack B3 Configuration Guide 3-49
clear tftp retry
UsethiscommandtoresettheTFTPretryvaluetothedefaultvalueof5retries.
Syntax
clear tftp retry
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampleshowshowtocleartheretryvaluetothedefaultof5retries.
B3(rw)-> clear tftp retry
Clearing and Closing the CLI
Purpose
TocleartheCLIscreenortocloseyourCLIsession.
Commands
ThecommandsusedtoclearandclosetheCLIsessionarelistedbelow.
cls (clear screen)
UsethiscommandtoclearthescreenforthecurrentCLIsession.
Syntax
cls
Parameters
None.
For information about... Refer to page...
cls 3-49
exit 3-50