Enterasys SecureStack B3 User Manual

clear port mirroring
5-32 Port Configuration
Defaults
None.
Mode
Switchcommand,read‐write.
Usage
NotethatLAGportsandtheirunderlyingphysicalports,asdescribedin“LinkAggregation
ControlProtocol(LACP)”onpage5‐34,cannotbemirrored.
Example
Thisexampleshowshowtocreateandenableportmirroringwithge.1.4asthesourceport,and
ge.1.11asthetargetport:
B3(su)->set port mirroring create ge.1.4 ge.1.11
B3(su)->set port mirroring enable ge.1.4 ge.1.11
clear port mirroring
Usethiscommandtoclearaportmirroringrelationship.
Syntax
clear port mirroring source destination
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampleshowshowtoclearportmirroringbetweensourceportge.1.4andtargetport
ge.1.11:
B3(su)->clear port mirroring ge.1.4 ge.1.11
set mirror vlan
AssignsaVLANtobereservedformirroringtraffic.IfamirroredVLANiscreated,allmirrored
trafficwillegressVLANtagged.AlltrafficonthemirrorVLANwillbeflooded.
Syntax
set mirror vlan vlan-id
source Specifiesthesourceportofthemirroringconfigurationtobecleared.For
adetaileddescriptionofpossibleport‐stringvalues,referto“PortString
SyntaxUsedintheCLI”onpage5‐1.
destination Specifiesthetargetportofthemirroringconfigurationtobecleared.

Enterasys SecureStack B3 Specifications

General

Brand	Enterasys
Model	SecureStack B3
Category	Switch
Language	English