Enterasys SecureStack B3

SecureStack B3 Configuration Guide 17-1
17
IP Configuration
ThischapterdescribestheInternetProtocol(IP)configurationsetofcommandsandhowtouse
them.
Configuring Routing Interface Settings
Purpose
Toenableroutinginterface conf igurationmodeonthedevice,tocreateroutinginterfaces,to
reviewtheusabilitystatusofinterfacesconfiguredforIP,tosetIPaddressesforinterfaces,to
enableinterfacesforIProutingatdevicestartup,andtoreviewtherunningconfiguration.
Commands
Router: Unless otherwise noted, the commands covered in this chapter can be executed only
when the device is in router mode. For details on how to enable router configuration modes, refer
to “Enabling Router Configuration Modes” on page 16-2.
For information about... Refer to page...
Configuring Routing Interface Settings 17-1
Reviewing and Configuring the ARP Table 17-7
Configuring Broadcast Settings 17-11
Reviewing IP Traffic and Configuring Routes 17-13
For information about... Refer to page...
show interface 17-2
interface 17-2
show ip interface 17-3
ip address 17-4
show running-config 17-5
no shutdown 17-6
no ip routing 17-6