Enterasys SecureStack B3

distance
SecureStack B3 Configuration Guide 18-3
None.
Defaults
None.
Mode
Interfaceconfiguration:B3(su)‐>router(Config‐if(Vlan1))#
Example
ThisexampleshowshowtoenableRIPontheVLAN1interface:
B3(su)->router(Config)#interface vlan 1
B3(su)->router(Config-if(Vlan 1))#ip rip enable
distance
UsethiscommandtoconfiguretheadministrativedistanceforRIProutes.Thenoformofthis
commandresetsRIPadministrativedistancetothedefaultvalueof120.
Syntax
distance weight
no distance [weight]
Parameters
Defaults
None.
Mode
Routerconfiguration:B3(su)‐>router(Config‐router)#
Usage
Ifseveralroutes(comingfromdifferentprotocols)arepresentedtotheSecureStackB3Route
TableManager(RTM),theprotocolwiththelowestadministrativedistancewillbechosenfor
routeinstallation.Bydefault,RIPadministrativedistanceissetto120.Thedistancecommandcan
beusedtochangethisvalue,resettingRIP’s
routepreferenceinrelationtootherroutesasshown
inthetablebelow.
Example
ThisexampleshowshowtochangethedefaultadministrativedistanceforRIPto1001:
B3(su)->router(Config)#router rip
weight SpecifiesanadministrativedistanceforRIProutes.Validvaluesare1‐255.
Route Source Default Distance
Connected 0
Static 1
RIP 120