Enterasys SecureStack B3

set dot1x
SecureStack B3 Configuration Guide 20-13
Server timeout: 30
Maximum requests: 2
Reauthentication period: 3600
Reauthentication control: Disabled
set dot1x
Usethiscommandtoenableordisable802.1Xauthentication,toreauthenticateoneormoreaccess
entities,ortoreinitializeoneormoresupplicants.
Syntax
set dot1x {enable | disable | port {init | reauth} {true | false} [port-string]}
Parameters
Defaults
Ifnoportsarespecified,thereinitializationorreauthenticationsettingwillbeappliedtoallports.
Mode
Switchcommand,read‐write.
Usage
Disabling802.1Xauthenticationglobally,bynotenteringaspecificport‐stringvalue,willenable
theEAPpass‐throughfeature.EAPpass‐throughallowsclientauthenticationpacketstobe
forwardedunmodifiedthroughtheswitchtoanupstreamdevice.
Examples
Thisexampleshowshowtoenable802.1X:
B3(su)->set dot1x enable
Thisexampleshowshowtoreinitializege.1.2:
B3(rw)->set dot1x port init true ge.1.2
set dot1x auth-config
Usethiscommandtoconfigure802.1Xauthentication.
Syntax
set dot1x auth-config {[authcontrolled-portcontrol {auto | forced-auth |
forced-unauth}] [maxreq value] [quietperiod value] [reauthenabled {false | true}]
enable|disable Enablesordisables8 02.1X.
port Enableordisable802.1Xreauthenti cationorinitialization controlononeor
moreports.
init|reauth Configureinitializationorreauthenticationcontrol.
true|false Enable(true)ordisable(false)reinitialization/reauthentication.
port‐string (Optional)Specifiestheport(s)toreinitializeorreauthenticate.