Enterasys SecureStack B3

show lldp port status
4-16 Discovery Protocol Configuration
Example
ThisexampleshowshowtodisplayLLDPconfigurationinformation.
B3(ro)->show lldp
Message Tx Interval : 30
Message Tx Hold Multiplier : 4
Notification Tx Interval : 5
MED Fast Start Count : 3
Tx-Enabled Ports : ge.1.1-60; ge.2.1-24; ge.3.1-30; ge.4.1-12;
Rx-Enabled Ports : ge.1.1-60; ge.2.1-24; ge.3.1-30; ge.4.1-12;
Trap-Enabled Ports : ge.1.1-60; ge.2.1-24; ge.3.1-30; ge.4.1-12;
MED Trap-Enabled Ports : ge.1.1-60; ge.2.1-24; ge.3.1-30; ge.4.1-12;
show lldp port status
UsethiscommandtodisplaytheLLDPstatusofoneormoreports.Thecommandliststheports
thatareenabledtosendandreceiveLLDPPDUs.Portsareenabledordisabledwiththesetlldp
portstatuscommand.
Syntax
show lldp port status [port-string]
Parameters
Defaults
Ifport‐stringisnotspecified,LLDPstatusinformationwillbedisplayedforallports.
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtodisplayLLDPportstatusinformationforallports.
B3(ro)->show lldp port status
Tx-Enabled Ports : ge.1.1-60; ge.2.1-24; ge.3.1-30; ge.4.1-12
Rx-Enabled Ports : ge.1.1-60; ge.2.1-24; ge.3.1-30; ge.4.1-12
show lldp port trap
UsethiscommandtodisplaytheportsthatareenabledtosendanLLDPnotificationwhena
remotesystemchangehasbeendetectedoranLLDP‐MEDnotificationwhenachangeinthe
topologyhasbeensensed.PortsareenabledtosendLLDPnotificationswiththesetlldpporttrap
command
andtosendLLDP‐MEDnotificationswiththesetlldpportmed‐trapcommand.
Syntax
show lldp port trap [port-string]
port‐string (Optional)DisplaysLLDPstatusforoneorarangeofports.