Enterasys SecureStack B3

set summertime date
SecureStack B3 Configuration Guide 3-17
Mode
Switchcommand,read‐only.
Example
Thisexampleshowshowtoenabledaylightsavingstimefunction:
B3(su)->set summertime enable
set summertime date
Usethiscommandtoconfigurespecificdatestostartandstopdayl ightsavingstime.These
settingswillbenon‐recurringandwillhavetoberesetannually.
Syntax
set summertime date start_month start_date start_year start_hr_min end_month
end_date end_year end_hr_min [offset_minutes]
Parameters
Defaults
Ifanoffsetisnotspecified,nonewillbeapplied.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtosetadaylightsavingstimestartdateofApril4,2004at2a.m.andan
endingdateofOctober31,2004at2a.m.withanoffsettimeofonehour:
B3(su)->set summertime date April 4 2004 02:00 October 31 2004 02:00 60
set summertime recurring
Usethiscommandtoconfigurerecurringdaylightsavingstimesettings.Thesesettingswillstart
andstopdaylightsavingstimeatthespecifieddayofthemonthandhoureachyearand willnot
havetoberesetannually.
start_month Specifiesthemonthoftheyeartostartdaylightsavingstime.
start_date Specifies
thedayofthemonthtostartdaylightsavingstime.
start_year Specifies theyeartostartdaylightsavingstime.
start_hr_min Specifiesthetimeofdaytostartdaylightsavingstime.Formatishh:mm.
end_month Specifiesthemonthoftheyeartoenddaylightsavingstime.
end_date Specifiesthedayofthemonthto
enddaylightsavingstime.
end_year Specifiestheyeartoenddaylightsavingstime.
end_hr_min Specifiesthetimeofdaytoenddaylightsavingstime.Formatishh:mm.
offset_minutes (Optional)Specifiestheamountoftimeinminutestooffsetdaylight
savingstimefromthenon‐daylightsavingstimesystemsetting.Valid
valuesare1‐
1440.