Enterasys SecureStack B3 - Clear Rmon Channel

clear rmon channel
14-16 RMON Configuration
Defaults
Ifanactionisnotspecified,packetswillbeacceptedonfiltermatches.
Ifnotspecified,controlwillbesettooff.
Ifadescriptionisnotspecified,nonewillbeapplied.
Ifownerisnotspecified,itwillbesettomonitor.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtocreateanRMONchannelentry:
B3(rw)->set rmon channel 54313 ge.2.12 accept failed control on description
"capture all"
clear rmon channel
UsethiscommandtoclearanRMONchannelentry.
Syntax
clear rmon channel index
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtoclearRMONchannelentry2:
B3(rw)->clear rmon channel 2
acceptmatched|
failed
(Optional)Specifiestheactionofthefiltersonthischannelas:
• matched‐Packetswillbeacceptedonfiltermatches
• failed‐Packetswillbeacceptediftheyfailamatch
controlon|off (Optional)Enablesordisablescontroloftheflowofdatathroughthe
channel.
description
description
(Optional)
Specifiesadescriptionforthischannel.
ownerowner (Optional)Specifiesthenameoftheentitythatconfiguredthisentry.
index Specifiesthechannelentrytobecleared.