Enterasys SecureStack B3

SecureStack B3 Configuration Guide 5-1
5
Port Configuration
ThischapterdescribesthePortConfigurationsetofcommandsandhowtousethem.
Port Configuration Summary
Port String Syntax Used in the CLI
Commandsrequiringaport‐stringparameterusethefollowingsyntaxtodesignateporttype,slot
location,andportnumber:
porttype.unitnumber.portnumber
Whereporttypecanbe:
fefor100‐MbpsEthernet
gefor1‐GbpsEthernet
tgfor10‐GbpsEthernet
hostforthehostport
vlanforvlaninterfaces
lagfor
IEEE802.3linkaggregationports
Unitnumbercanbe:
1‐8forswitchunitsinaSecureStackB3stack
For information about... Refer to page...
Port Configuration Summary 5-1
Reviewing Port Status 5-2
Disabling / Enabling and Naming Ports 5-6
Setting Speed and Duplex Mode 5-8
Enabling / Disabling Jumbo Frame Support 5-11
Setting Auto-Negotiation and Advertised Ability 5-13
Setting Flow Control 5-16
Setting Port Link Traps and Link Flap Detection 5-18
Configuring Broadcast Suppression 5-27
Port Mirroring 5-29
Link Aggregation Control Protocol (LACP) 5-34
Configuring Protected Ports 5-47