Enterasys SecureStack B3 User Manual

DiffServ Configuration Examples
SecureStack B3 Configuration Guide 9-17
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtoapplytheDiffservpolicynamed“admin”toincomingtrafficonports
ge1.1‐10:
B3(rw)->set diffserv service add in ge.1.5 admin
DiffServ Configuration Examples
Typically,youwouldusetheDiffservcommandsettocompleteconfigurationtasksinthe
followingorder:
1. EnableDiffServ.
2. CreateaClass.
3. CreateoneormoreclassificationruleswithintheClass.
4. CreateaPolicy.
5. AddoneormoreClassestothePolicy.
6. AddPolicing(Conforming/Non‐conforming,Drop/Forward,RateLimit,Precedence/DSCP
Rewrite)actionsorjustMarking
(Precedence/DSCPRewrite)actionstothePolicy.
7. AssignthePolicytooneormoreports.
ThefollowingexamplesshowhowtoproceedthroughthesetaskstocreateDiffServpolicies.
Thisexamplecreatestwoseparatepolicies:
a. policyef—rate‐limitsingressedtrafficonportfe.1.1toamaximumof100Mb/s,andon
the
sametraffi,calsorewritesthesixDSCPbitstoadecimalvalueof46forExpress
Forwardingonlayer3.
b. policyaf31—rate‐limitsingressedtrafficonportfe.1.2toamaximumof100Mb/s,andon
thesametraffic,alsorewritesthesixDSCPbitstoadecimalvalueof
26forFlash
forwardingonlayer3.
B3(rw)->set diffserv adminmode enable
B3(rw)->set diffserv class create all classevery
B3(rw)->set diffserv class match every classevery
B3(rw)->set diffserv policy create policyef in
B3(rw)->set diffserv policy class add policyef classevery
B3(rw)->set diffserv policy police style simple policyef classevery 100000 128
B3(rw)->set diffserv policy police action conform markdscp policyef classevery ef
B3(rw)->set diffserv policy create policyaf31 in
B3(rw)->set diffserv policy class add policyaf31 classevery
B3(rw)->set diffserv policy police style simple policyaf31 classevery 100000 128
B3(rw)->set diffserv policy police action conform markdscp policyaf31 classevery
af31
B3(rw)->set diffserv service add in fe.1.1 policyef
B3(rw)->set diffserv service add in fe.1.2 policyaf31

Enterasys SecureStack B3 Specifications

General

Ports	24 or 48 10/100/1000BASE-T ports
Forwarding Rate	95.2 Mpps
Layer	Layer 2/3
Power Supply	Internal
Redundant Power Supply	Optional
VLANs Supported	4094
Uplink Ports	4 SFP ports
Dimensions	44.0 x 43.7 x 4.4 cm
Weight	11.9 lbs (5.4 kg)
MAC Address Table Size	16, 000 entries
Jumbo Frame Support	Up to 9, 216 bytes
Power over Ethernet	PoE+
Operating Temperature	0°C to 50°C
Storage Temperature	-20 °C to 70 °C
Humidity	10% to 95% (non-condensing)