Enterasys SecureStack B3

clear rmon history
SecureStack B3 Configuration Guide 14-7
clear rmon history
UsethiscommandtodeleteoneormoreRMONhistoryentriesorresetoneormoreentriesto
defaultvalues.Forspecificvalues,referto“setrmonhistory”onpage 14‐6.
Syntax
clear rmon history {index-list | to-defaults}
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtodeleteRMONhistoryentry1:
B3(rw)->clear rmon history 1
Alarm Group Commands
Purpose
Todisplay,configure,andclearRMONalarmentriesandproperties.
Commands
show rmon alarm
UsethiscommandtodisplayRMONalarmentries.TheRMONalarmgroupperiodicallytakes
statisticalsamplesfromRMONvariablesandcomparesthemwithpreviouslyconfigured
thresholds.IfthemonitoredvariablecrossesathresholdanRMONeventisgenerated.
index‐list Specifiesoneormorehistoryentriestobedeleted,causingthemto

disappearfromanyfutureRM ONqueries.
to‐defaults Resetsallhistoryentriestodefaultvalues.Thiswillcauseentriesto
reappearinRMONqueries.
For information about... Refer to page...
show rmon alarm 14-7
set rmon alarm properties 14-9
set rmon alarm status 14-10
clear rmon alarm 14-10