Enterasys SecureStack B3

clear port priority-queue
11-6 Port Priority Configuration
Example
Thisexampleshowshowtosetpriority5framesreceivedonge.2.12totransmitonqueue0.
B3(su)->set port priority-queue ge.2.12 5 0
clear port priority-queue
Usethiscommandtoresetportpriorityqueuesettingsbacktodefaultsforoneormoreports.
Syntax
clear port priority-queue port-string
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampleshowshowtoclearthepriorityqueuesettingsonge.2.12:
B3(su)->clear port priority-queue ge.2.12
Configuring Quality of Service (QoS)
Purpose
Eighttransmitqueuesareimplementedintheswitchhardwareforeachport,butonlysixare
availableforuseinprioritizingvariousdataandcontroltraffic.Theseventhandeighthqueuesare
reservedforstacking(ifapplicable)andnetworkcontrolrelatedcommunications.
Thecommandsinthissectionallowyoutoset
theprioritymodeandweightforeachofthe
availablesixqueues(queues0through5)foreachphysicalportontheswitch.Prioritymodeand
weightcannotbeconfiguredonLAGs,onlyonthephysicalportsthatmakeuptheLAG.
Commands
port‐string Specifiestheportforwhichtoclearpriority‐to‐queuemappings.Fora
detaileddescriptionofpossibleport‐stringvalues,referto“PortString
SyntaxUsedintheCLI”onpage 5‐1.
For information about... Refer to page...
show port txq 11-7
set port txq 11-7
clear port txq 11-8