Enterasys SecureStack B3

clear host vlan
8-18 802.1Q VLAN Configuration
Mode
Switchcommand,read‐write.
Usage
ThehostVLANshouldbeasecureVLANwhereonlydesignatedusersareallowedaccess.For
example,ahostVLANcouldbespecificallycreatedfordevicemanagement.Thiswouldallowa 
managementstationconnectedtothemanagementVLANtomanageallportsonthedeviceand
makemanagementsecurebypreventing
managementviaportsassignedtootherVLANs.
Example
ThisexampleshowshowtosetVLAN7asthehostVLAN:
B3(su)->set host vlan 7
clear host vlan
UsethiscommandtoresetthehostVLANtothedefaultsettingof1.
Syntax
clear host vlan
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtosetthehostVLANtothedefaultsetting:
B3(su)->clear host vlan
Enabling/Disabling GVRP (GARP VLAN Registration Protocol)
About GARP VLAN Registration Protocol (GVRP)
Thefollowingsectionsdesc ribethedeviceoperationwhenitsportsareoperatingunderthe
GenericAttributeRegistrationProtocol(GARP)application–GARPVLANRegistrationProtocol
(GVRP).
Note: Before you can designate a VLAN as the host VLAN, you must create a VLAN using the set
of commands described in “Creating and Naming Static VLANs” on page 8-4.