Enterasys SecureStack B3

set pwa portcontrol
SecureStack B3 Configuration Guide 20-67
Example
ThisexampleshowshowtosetthePWAmaximumrequeststo3forallports:
B3(su)->set pwa maxrequests 3
set pwa portcontrol
ThiscommandenablesordisablesPWAauthenticationonselectports.
Syntax
set pwa portcontrol {enable | disable} [port-string]
Parameters
Defaults
Ifport‐stringisnotspecified,PWAwillenabledonallports.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtoenablePWAonports1‐22:
B3(su)->set pwa portcontrol enable ge.1.1-22
show pwa session
UsethiscommandtodisplayinformationaboutcurrentPWAsessions.
Syntax
show pwa session [port-string]
Parameters
Defaults
Ifport‐stringisnotspecified,sessioninformationforallportswillbedisplayed.
Mode
Switchcommand,read‐only.
enable|disable EnablesordisablesPWAonspecifiedports.
port‐string (Optional)Setsthecontrolmodeonspecificport(s).Foradetailed
descriptionofpossibleport‐stringvalues,referto“PortStringSyntaxUsed
intheCLI”onpage 5 ‐1.
port‐string (Optional)DisplaysPWAsessioninformationforspecificport(s).For a
detaileddescriptionofpossibleport‐stringvalues,referto“PortString
SyntaxUsedintheCLI”onpage 5‐1.