Enterasys SecureStack B3

show lacp
SecureStack B3 Configuration Guide 5-37
show lacp
Usethiscommandtodisplayinformationaboutoneormoreaggregatorports.
Syntax
show lacp [port-string]
Parameters
Defaults
Ifport‐stringisnotspecified,linkaggregationinformationforallLAGswillbedisplayed.
Mode
Switchcommand,read‐only.
Usage
EachSecureStackB3moduleprovides6virtuallinkaggregatorports,whicharedesignatedinthe
CLIaslag.0.1throughlag.0.6.Onceunderlyingphysicalports(thatis,
ge.x.x)areassociatedwith
anaggregatorport,theresultingaggregationwillberepresentedasoneLinkAggregationGroup
(LAG)withalag.x.xportdesignation.
Example
Thisexampleshowshowtodisplaylacpinformationforlag.0.1.Thefollowingtabledescribesthe
outputfields.
B3(su)->show lacp lag.0.1
Global Link Aggregation state: enabled
Single Port LAGs: disabled
Aggregator: lag.0.1
Actor Partner
System Identifier: 00:01:F4:5F:1E:20 00:11:88:11:74:F9
System Priority: 32768 32768
Admin Key: 32768
Oper Key: 32768 0
Attached Ports: ge.1.1
ge.1.3
Table 5‐6providesanexplanationofthecommandoutput.
clear lacp singleportlag 5-41
show port lacp 5-42
set port lacp 5-44
clear port lacp 5-46
For information about... Refer to page...
port‐string (Optional)DisplaysLACPinformationforspecificLAGport(s).Valid
portdesignationsarelag.0.1‐6.