Enterasys SecureStack B3

show spantree vlanlist
SecureStack B3 Configuration Guide 7-15
show spantree vlanlist
UsethiscommandtodisplaytheSpanningTreeID(s)assignedtooneormoreVLANs.
Syntax
show spantree vlanlist [vlan-list]
Parameters
Defaults
Ifnotspecified,SIDassignmentwillbedisplayedforallVLANs.
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtodisplaytheSIDsmappedtoVLAN1.Inthiscase,SIDs2,16and42
aremappedtoVLAN1.Forthisinformationtodisplay,theSIDins ta n cemustbecreatedusing
thesetspantreemsticommandasdescribedin“setspantreemsti”onpage 7
‐12,andtheFIDs
mustbemappedtoSID 1usingthesetspantreemstmapcommandasdescribedin“setspantree
mstmap”onpage 7 ‐14 :
B3(su)->show spantree vlanlist 1
The following SIDS are assigned to VLAN 1: 2 16 42
show spantree mstcfgid
UsethiscommandtodisplaytheMSTconfigurationidentifierelements,includingformatselector,
configurationname,revisionlevel,andconfigurationdigest.
Syntax
show spantree mstcfgid
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtodisplaytheMSTconfigurationidentifierelements.Inthiscase,the
defaultrevisionlevelof0,andthedefaultconfigurationname(astringrepresentingthebridge
MACaddress)havenotbeenchanged.Forinformationonusingthesetspantreemstcfgid
commandtochangethesesettings,referto
“setspantreemstcfgid”onpage 7‐16:
vlan‐list (Optional)DisplaysSIDsassignedtospecificVLAN(s).