Enterasys SecureStack B3

set diffserv adminmode
9-2 Differentiated Services Configuration
set diffserv adminmode
UsethiscommandtogloballyenableordisableDiffservonthedevice.Bydefault,thisfunctionis
disabledatdevicestartup.
Syntax
set diffserv adminmode {enable | disable}
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtoenableDiffserv:
B3(rw)->set diffserv adminmode enable
Creating Diffserv Classes and Matching Conditions
Purpose
Toreview,create,andconfigureDiffservclassesandmatchingconditions.
Commands
Thecommandsusedtoreview,create,andconfigureDiffservclassesandmatchingconditionsare
listedbelowanddescribedintheassociatedsectionasshown.
show diffserv info
UsethiscommandtodisplaygeneralDiffservstatusinformation.
enable|disable EnablesordisablesDiffserv.
For information about... Refer to page...
show diffserv info 9-2
show diffserv class 9-3
set diffserv class create 9-4
set diffserv class delete 9-4
set diffserv class match 9-5
set diffserv class rename 9-8