Enterasys SecureStack B3

set pwa ipaddress
20-62 Security Configuration
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtohidetheEnterasysNetworkslogo:
B3(su)->set pwa displaylogo hide
set pwa ipaddress
UsethiscommandtosetthePWAIPaddress.ThisistheIPaddressoftheendstationfromwhich
PWAwillpreventnetworkaccessuntiltheuserisauthenticated.
Syntax
set pwa ipaddress ip-address
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtosetaPWAIPaddressof1.2.3.4:
B3(su)->set pwa ipaddress 1.2.3.4
set pwa protocol
Usethiscommandtosettheportwebauthenticationprotocol.
Syntax
set pwa protocol {chap | pap}
ip‐address SpecifiesagloballyuniqueIPaddress.Thissamevaluemustbe 
configuredintoeveryauthenticatingswitchinthedomain.