Enterasys SecureStack B3

clear spantree spanguard
7-26 Spanning Tree Configuration
clear spantree spanguard
UsethiscommandtoresetthestatusoftheSpanningTreeSpanGuardfunctiontodisabled.
Syntax
clear spantree spanguard
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtoresetthestatusoftheSpanGuardfunctiontodisabled:
B3(rw)->clear spantree spanguard
show spantree spanguardtimeout
UsethiscommandtodisplaytheSpanningTreeSpanGuardtimeoutsetting.
Syntax
show spantree spanguardtimeout
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtodisplaytheSpanGuardtimeou tsetting:
B3(su)->show spantree spanguardtimeout
Spanguard timeout: 300
set spantree spanguardtimeout
Usethiscommandtosettheamountoftime(inseconds)anedgeportwillremainlockedbythe
SpanGuardfunction.