Enterasys SecureStack B3

show spantree adminedge
SecureStack B3 Configuration Guide 7-37
Parameters
Defaults
Ifsidisnotspecified,adminpathcostwillberesetforSpanningTree0.
Mode
Switchcommand,read‐write.
Example
Thisexampleshowshowtoresettheadminpathcostto0forge.3.2onSID1:
B3(su)->clear spantree adminpathcost ge.3.2 sid 1
show spantree adminedge
Usethiscommandtodisplaytheedgeportadministrativestatusforaport.
Syntax
show spantree adminedge [port port-string]
Parameters
Defaults
Ifport‐stringisnotspecifiededgeportadministrativestatuswillbedisplayedforallSpanning
Treeports.
Mode
Switchcommand,read‐only.
Example
Thisexampleshowshowtodisplaytheedgeportstatusforge.3.2:
B3(su)->show spantree adminedge port ge.3.2
Port ge.3.2 has a Port Admin Edge of Edge-Port
set spantree adminedge
UsethiscommandtosettheedgeportadministrativestatusonaSpanningTreeport.
port‐string Specifiestheport(s)forwhichtoresetadminpathcost.Foradetailed
descriptionofpossibleport‐stringvalues,referto“PortStringSyntax
UsedintheCLI”onpage 5‐1.
sidsid (Optional)Resets
theadminpathcostforspecificSpanningTree(s).
Validvaluesare0‐4094.If notsp ecified,SID0isassumed.
port‐string (Optional)Displaysedgeportadministrativestatusforspecific
port(s).Foradetaileddescriptionofpossibleport‐stringvalues,
referto“PortStringSyntaxUsedintheCLI”onpage 5‐1.