Enterasys SecureStack B3 - Clear Cos Port-Resource

clear cos port-resource
SecureStack B3 Configuration Guide 10-27
Defaults
IfaportgroupandIRLindexarenotspecified,theIRLconfigurationforallresources(0‐99)forall
configuredportgroupswillbeshown.
Mode
Switchcommand,read‐only.
Example
ThisexampledisplaystheIRLresourceindexnumber1configurationforgroup2.0. 
B3(su)->show cos port-resource irl 2.0 1
'?' after the rate value indicates an invalid rate value
Group Index Resource Type Unit Rate Rate Limit Type Action
----------- -------- ---- ---- ---------- --------------- ------
2.0 1 irl kbps 10000 drop none
clear cos port-resource
UsethiscommandtosettheinboundratelimitinKbps.
Syntax
clear cos port-resource irl {all | group-type-index [irl-index [unit] [rate]
[type]]}
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
irl SpecifiesthatanIRLresourceistobecleared.
all ClearallIRLresourcesforallportgroups.
group‐type‐index Specifiesaninboundratelimitingportgroup/typeindex.Validentriesare
intheformofgroup#.port‐type.
Validvaluesforgroup#canrangefrom0to7.
Validvaluesforport‐type
canrangefrom0to1,althoughonlyporttype0iscurrentlysupported.
Forexample,portgroup3wouldbespecifiedas3.0.
irl‐index (Optional)Inboundratelimiterresourceindexassociatedwiththe
specifiedportgroup.Validvaluesrangefrom0to99.
unit
Cleartheunitofmeasurefortheinboundratelimiter.
rate Clearthedatarateforthisinboundratelimiter.
type Cleartheactionfortheratelimiter.