Enterasys SecureStack B3

ip irdp enable
18-10 IPv4 Routing Protocol Configuration
ip irdp enable
UsethiscommandtoenableIRDPonaninterface.ThenoformofthiscommanddisablesIRDPon
aninterface.
Syntax
ip irdp enable
no ip irdp enable
Parameters
None.
Defaults
None.
Mode
Interfaceconfiguration:B3(su)‐>router(Config‐if(Vlan1))#
Example
ThisexampleshowshowtoenableIRDPontheVLAN1interface:
B3(su)->router(Config)#interface vlan 1
B3(su)->router(Config-if(Vlan 1))#ip irdp enable
ip irdp maxadvertinterval
UsethiscommandtosetthemaximumintervalinsecondsbetweenIRDPadvertisements.Theno
formofthiscommandresetsthemaximumadvertisementintervaltothedefaultvalueof600
seconds.
Syntax
ip irdp maxadvertinterval interval
no irdp maxadvertinterval
Parameters
Defaults
None.
ip irdp holdtime 18-11
ip irdp preference 18-12
ip irdp broadcast 18-13
show ip irdp 18-13
For information about... Refer to page...
interval Specifiesamaximumadvertisementintervalinseconds.Validvaluesare
4to1800.