Enterasys SecureStack B3

Packet Capture Commands
SecureStack B3 Configuration Guide 14-19
Example
ThisexampleshowshowtoclearRMONfilterentry1:
B3(rw)->clear rmon filter index 1
Packet Capture Commands
Notethatpacketcapturefilterissamplingonlyanddoesnotguarantee receiptofback‐to‐back
packets.
Purpose
TodisplayRMONcaptureentries,configure,enable,ordisablecaptureentries,andclearcapture
entries.
Commands
show rmon capture
UsethiscommandtodisplayRMONcaptureentriesandassociatedbuffercontrolentries.
Syntax
show rmon capture [index [nodata]]
Parameters
Defaults
Ifnooptionsarespecified,allbuffercontrolentriesandassociatedcapturedpacketswillbe
displayed.
Mode
Switchcommand,read‐only.
For information about... Refer to page...
show rmon capture 14-19
set rmon capture 14-20
clear rmon capture 14-21
index (Optional)Displaysthespecifiedbuffercontrolentryandallcaptured
packetsassociatedwiththatentry.
nodata (Optional)Displaysonlythebuffercontrolentryspecifiedbyindex.