Enterasys SecureStack B3

set cos settings
10-20 Policy Classification Configuration
Syntax
clear cos state
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtocleartheCoSstatebacktoitsdefaultsettingofdisabled:
B3(su)->clear cos state
set cos settings
UsethiscommandtoconfigureaClassofServiceentryintheCoSsettingstable.
Syntax
set cos settings cos-index priority priority [tos-value tos-value][irl-reference
irl-reference]
Parameters
Defaults
Ifnooptionalparametersarespecified,nonewillbeapplied.
Mode
Switchcommand,read‐write.
Usage
TheCoSsettingstabletakesindividualclassofservicefeaturesanddisplaysthemasbelongingto
aCoSentry. Essentially,itisusedforCoSfeatureassignment.Eachclassofserviceentryconsists
ofanindex,802.1ppriority,anoptionalToSvalue,andanIRLreference.
cos‐index SpecifiesaClassof
Serviceentry.Validvaluesare0to255.
prioritypriority Specifiesan802.1dpriorityvalue.Validvaluesare0to7,with0beingthe
lowestpriority.SeeUsagesectionbelowformoreinformation.
tos‐valuetos‐value (Optional)Specifiesa TypeofServicevalue.Validvaluesare0to255.
See
Usagesectionbelowformoreinformation.
irl‐reference
irl‐reference
(Optional)Settheinboundratelimiterassociatedwiththisentry.Valid
valuesare0to99.SeeUsagesectionbelowformoreinformation.